TECHNO PAINT
Sealer
Acrylic Sealer
Water-based acrylic sealer that binds chalky substrates and improves topcoat adhesion. Lays a uniform base for emulsions.
- Type
- Water-based acrylic
- Coverage
- 10–12 m²/L
- Recoat
- 2–4 hrs
- Pack
- 4 L · 20 L
Seven finishes engineered for Nigerian interiors — from building contractors finishing an entire estate to a homeowner freshening a single living room. Washable, breathable, and tuned for tropical humidity.
Every product below is manufactured at our Idu Industrial Area plant and quality-checked against our internal specification before it leaves the factory.
Sealer
Water-based acrylic sealer that binds chalky substrates and improves topcoat adhesion. Lays a uniform base for emulsions.
Filler
Ready-to-use acrylic wall filler for levelling plaster, filling cracks and smoothing out imperfections before priming. Sands cleanly.
Washable
A rubberised acrylic emulsion with superior wash resistance. Specified for hospitality, kitchens and high-traffic corridors where walls see constant contact.
Velvet matt
Our top-tier emulsion. Higher pigment load, tighter colour fidelity, and a smooth velvet matt finish — formulated for feature walls and prestige interiors.
Satin · Silk
A soft-sheen water-based finish that reflects light gently. Moisture-resistant and easy to clean — the right call for bathrooms, kitchens and children's rooms.
Eggshell
A low-sheen finish sitting between matt and satin. The contractor's choice for trim, doors and high-touch surfaces — durable without looking plasticky.
A recommended system for interior walls. Deviate where the site demands — our technical team will specify if asked.
Every interior specification we write for our contractor partners follows the same spine: prep, seal, fill, finish. What changes is the product — an eggshell for trim, a rubber emulsion for a restaurant kitchen, a premium emulsion for a feature wall.
Drying times on this page are given at 25 °C. Hot, dry afternoons in Abuja will recoat faster; damp rainy-season days will take longer.
Sand the substrate, remove dust, wash off grease. Allow new plaster to cure fully (at least 28 days).
One coat of Acrylic Sealer. Allow 4–6 hrs to dry, then apply Putty Filler to even out the surface. Sand smooth.
Apply the chosen emulsion or finish. Work in one direction, lay off with light strokes. Allow 4–6 hrs before recoating.
A full second coat completes the system. Colour and film reach full development after 48 hrs.
We write paint specifications for contractors, interior designers and estate developers across Nigeria. Send us the surface area and we'll come back with quantities, system and price.